Home/Electrical
  • Grommet Set (2) to fit into Cam/Breaker Covers. Set includes two grommets without holes. Fits: XS 650's - Use on all Tci models (1980-84 factory ignition). Part #14-0776 $3.95 Ea.
  • Out of stock
    Contact Breaker Plate Assembly Lead. Part #14-0777 $4.50 Ea.  
  • Out of stock
    Electronic ignition - XS650 Standard Ignition by Pamco, a proven reliable electronic trigger system that replaces the stock XS650 breaker point type ignition. Works with original advance assembly parts and is an easy set & forget install. Fits: All 1970-1984 XS650's Basic unit only - Requires a dual output coil (2.2-3 OHM primary) plus stock parts usual on a 1970-79 650. (If needed these parts are available separate or in other kits offered on this site).Note: For 1980-84 North American models see other kit versions which include the advance parts needed that are normally absent on the 1980-84 models. Part #14-0900 $99.95 Ea.
  • Out of stock
    Electronic Ignition for XS650 with 277 degree rephased engine 277 Ignition by Pamco, a proven reliable electronic trigger system that replaces the stock XS650 breaker point type ignition. Works with original advance assembly parts and is an easy set & forget install. Fits: All 1970-1984 XS650's Basic unit only - Requires a dual output coil (2.2-3 OHM primary) plus stock parts usual on a 1970-79 650. (If needed these parts are available separate or in other kits offered on this site).Note: For 1980-84 North American models see other kit versions which include the advance parts needed that are normally absent on the 1980-84 models.   Part #14-0904 $99.95 Ea.
  • High Output Replacement Ignition Coil. Fits: 80-84 XS650's with Factory TCI ignition (dual lead -1 used per bike).Used on 80-84 models Only, and is Not for contact point systems. Mounts to stock brackets. Plug Wires not included. Not for use with Boyer Ignitions. Mount this coil to stock bracket on opposite side and with high tension plug wires facing to front of bike (Red/White wire from stock harness goes to + terminal on coil). WARNING!!! Do not operate or apply power to the ignition system with one or both spark plugs disconnected. Operating or applying power to the coil or ignition system with one or both spark plugs disconnected will cause IMMEDIATE FAILURE to the coil. Ignition coils are NOT WARRANTIED for this reason. Part #17-6803 $29.90 Ea.
  • Replacement Coil Tower Caps and Seals Set. One set (2 Coil Tower Caps + 2 Seals). Fits the 2 coils used with stock points ignition coils or our XS#17-6803 High output replacement Tci ignition coil (A single dual output coil). Part #17-6804 $3.50 Ea.
  • Out of stock
    Ignition Coil - Exact Replacement Original Type Coil for all 650's with Contact Point Ignitions. Replaces original coils that are weak from heat and age and restores spark strength to the ignition system. Hitachi type CM11-50/50B/52A 4 Ohm primary - Plug wires not included. OEM Ref.# 254-82310-60-00. 2 Required per bike. Part #17-6805 $19.95 Ea.
  • Ultimate High Output Replacement Coil. Replaces stock factory Tci ignition coils.12 Volt. Primary resistance 2.45 OHMs. Secondary resistance 15ak OHMs 6.6mm. mounting holes spaced at 102mm. mounting holes center to center. Warning: Serious High Voltage Possible Output as high as 82 Kv Caution! Do not operate or apply power to the ignition system with one or both spark plugs disconnected. Do not leave the ignition on with the engine not running. Warranty is void if operated with one or both spark plugs disconnected or if the ignition is left on with the engine not running. Part #17-6903 $52.95 Ea.
  • Left Hand Crankcase Cover Gasket. OEM Ref.# 256-15451-00. Fits: 1970-71 XS1/XS1b Only.   Part #18-0674 $6.95 Ea.
  • Gear Train Cover Gasket - Gasket for cover that is removed when installing the starter block-off plug. (This gasket is located below front sprocket and under left hand engine case). OEM Ref.# 306-15452-00. Fits: 1972-84 650's.   Part #18-0859 $3.80 Ea.
  • Left Hand Crankcase Cover Gasket. OEM Ref.# 306-15461-00. Fits: 1972-84 650's.   Part #18-0869 $6.50 Ea.
  • 7mm. Spark Plug High Tension Wires - Original Type - Copper Core with Black Rubber Casing 1 Set/2 x 20" Part #23-2902 $4.20 Ea.
  • 7mm. Spark Plug High Tension Wires - Original Type - Copper Core with Black Rubber Casing 1 Set/2 x 20" Part #23-2903 $19.00 Ea.
  • XS Performance 7mm. Silicone High Tension Spark Plug Wire .25' Roll. Yellow Color with Copper Core. Part #23-2905 $29.00 Roll
  • XS Performance 7mm. Silicone High Tension Spark Plug Wire Set (2 Pc.x 20.5") Yellow Color with Copper Core. Part #23-2906 $6.30 Ea.
  • Out of stock
    NGK Resistor Spark Plug Cap (5K Ohms). This Factory Original XS650 type can be used with All electronic ignitions (spark plugs with threaded stud type terminal end).
    Part #23-3113 $2.95 Ea.
Go to Top