| Drain Plug Crush Gaskets - (Pk./2) - Each Engine has 2 Drain Plugs. Replaces OEM# 256-15353-00. 18067-004 40mm. Dia. Copper 11009-1866 Part #17-3802 $3.50 Pk./2 |
-
-
Out of stock
Copper Washers - Pk./10 for Heiden Filter Cooler # 15-6504 Mounting Bolts. Washers also fit clutch cover socket screws (Oem Ref. # 90430-0601418-0903). Part #18-0886 $3.80 -
Sump Oil Filter Strainer Plate Gasket. Fits: All 650's 1970-84. Part #18-0858 $3.80 -
Gear Train Cover Gasket - Gasket for cover that is removed when installing the starter block-off plug. (This gasket is located below front sprocket and under left hand engine case). OEM Ref.# 306-15452-00. Fits: 1972-84 650's. Part #18-0859 $3.80 Ea. -
Sale!
Starter Motor Shaft Oil Seal. OEM #93101-17047-00. SDO 17-28-8 HS Fits: All 650 starter motors 1972-84. Part #01-9027 $6.00 Ea. -
Out of stock
Engine Tachometer Drive Oil Seal. OEM.#93104-07036. Ars SO 7-13-4 HS. Fits: All 650's 1970-84. Part #01-9023 $4.80 Ea. -
Out of stock
Clutch Pushrod Oil Seal - Made in Japan by Original Maker. OEM Ref.# 93102-08094/08118 ( SD - 8-25-6 ) Ars. Fits: 1970-84 650's Note: The Clutch pushrod seal is a chronic leaker. This seal was made to be replaced when the engine cases are split! It can be replaced without splitting the cases but it is tricky to drive it in intact. We suggest riders purchase more than one as you will need another again someday if not right away if you do not succeed in replacing the seal intact. We suggest you also clean and polish your clutch pushrod as grit & nicks on the rod will saw away at the seal lip causing early wear. Part #01-9019 $4.85 Pc. -
Intake Spiggot Gasket (Pk./2) Intake Spiggot Gasket (Carb Holder Rubber) (Pk./2), OEM Ref.# 256-13556-01. Fits: Between XS650 Manifolds (Carb Spacers) and cylinder head and between the XS manifolds and the carb holders for the PWK 32. Fits: 1970-84 650's Keihin Flatslide PWK 32mm XS Performance Carb Set for XS650. And All Stock Carb Holders. Note: 2 sets required. Part #18-0865 $4.90/Pk./2 -
Out of stock
Starter motor Housing O-Rings ( Pk./2 ) - Square profile Oem Ref.# 306-81827-10-00 Fits: All 650' Starters (1972-84). Part #01-9028 $4.90/Pk./2 -
Engine Transmission Shift Shaft Oil Seal. OEM.# 93109-14010. Ars SDD 14-24-6. Fits: All 650's 1970-84. Part #01-9026 $5.00 Ea. -
Top End Copper Sealing Washer Kit - 9 pc. Kit Contains: 1pc. # 90430-14043 ( @ Oil feed tube base at crankcase), 4 pc. # 90430-10027 ( @ Oil feed tube - Top of head at bolts), 2 pc. # 90430-11033 (@ Rear of cam chain guide support nuts to cylinder front), 2 pc. # 90430-06014 @ (Cam chain guide fastening bolts at front of cylinder). Fits: All 650's Part #18-0870 $5.50 -
Left Hand Crankcase Cover Gasket. OEM Ref.# 306-15461-00. Fits: 1972-84 650's. Part #18-0869 $6.50 Ea. -
Bottom End Copper Sealing Washer Kit - 13 pc. Kit Contains: 6pc.of # 90430-08143-00 ( @ Crankcase Bottom - Nut washers), 2 pc.of #90430-06014 ( @ Oil filter cover screws in clutch case), 3 pc. 90430-06014 ( @ 3 Clutch case upper front screws), 1 pc. of # 90430-06014 ( @ Tach drive retaining bolt ), 1pc. 37R-82543-00/90430-11034 ( @ Neutral switch base ). Fits: All 650's. Part #18-0871 $6.50/Kit -
Out of stock
Engine Kickstart Shaft Oil Seal. OEM.#93102-25064. Ars SD 25-35-7-2HS. Fits: All 650's 1970-84. Part #01-9024 $6.90 Ea. -
Left Hand Crankcase Cover Gasket. OEM Ref.# 256-15451-00. Fits: 1970-71 XS1/XS1b Only. Part #18-0674 $6.95 Ea. -
Out of stock
Starter Motor to Crankcase Oil Seal. OEM.#93102-34095. Ars SD34-46-10.5 Fits: All 1972-84 650's. Part #01-9022 $6.95 Ea.