| Circular Spark Plug Gap Tool. Marked in thousandths of an inch and millimeters. Part #35-0136 $1.95 ea. | |||||||
-
Out of stock
-
Out of stock
Ring Wrench to Adjust Shock Preload. Fits: Our 06-3601/06-3607/06-3608/06-3621/06-3627/06-3641 & 06-3647 shock sets and many other aftermarket shocks. Part #35-5033 $2.90 Ea. -
Out of stock
Ring Wrench Ring Wrench to Tighten Muffler Joint Nut on Early XS1 Type Muffler Part #35-5029 $2.95 Ea. -
Out of stock
Spoke Wrench Set - A Must Have for Lacing, Truing & Tightening Spokes. 2 Pc. Set. Fits: #8, 9, 10 & 11 Nipple Sizes. Part #35-0109 $4.20/Set/2 -
Chain Press Tool. Used to press on side plates (rivet or clip type) onto rear drive chains. Most late-type High strength drive chains now use a press on side plate on the connecting link (including IZUMI 530 HT). Part #35-0081 $4.95 Ea.
-
Out of stock
Replacement Breaker Pin for Cam Chain Breaker Tool. Part #35-0117 $5.50 Set -
Out of stock
Drive Chain Rivet Tool Replacement Rivet Pin. Fits: Drive Chain Riveter Tool #35-0006 Part #35-0007 $5.55 Ea. -
Out of stock
Valve Guide Install / Remove Driver Tool for 1970-84 650's. Part #35-0077 $5.60 Set -
Damper Bolt Driver 8mm Hex - Deep type damper bolt driver used to air impact recessed damper bolts from lower fork legs. 8mm. x 92 Fits: Stock forks 1973-84 Part #35-5022 $5.95 Ea. -
Out of stock
Valve Lapping Sticks - Part #35-0059 $6.25Set/2. -
Out of stock
17mm. Hex (Allen) Bit Tool to Remove Fork Tube Top Caps. A perfect fit to remove those soft alloy fork tube caps without damage. Fits: Fork caps on TX650A (1974), XS650BC (75-76) and 1977D (version without preload adjuster). Part #35-1081 $6.25 Ea. -
Cable Luber - Yamaha Pressure Type (Sold Each) Water & dirt are blown down cable by lubricant when pressure spray can nozzle is applied. Spray lube sold by most bike shops. Part #35-0108 $6.95 Ea. -
Tire Lever - 16" Long Dunlop Type - For those tough tires needing lots of leverage to remove. You need 2-3 of these to do the job! Part #35-0080 $6.95 Ea. -
Out of stock
1/2" Drive 27mm. 6 Point Deep Socket. Fits: Clutch Hub Nut on All 650's 1970-84. Part #35-1078 $7.50 ea. -
Out of stock
Tool for Installing and Removing Spoke or Mag Type Wheel Weights. Part #35-9059 $8.40 Ea.
-
Clutch Holder Tool - Holds Inner and Outer Clutch Hubs So That the Center Nut May be Removed Without Damaging Hubs. Fits: All 650 clutches (1970-84). Part #35-5021 $7.95 ea.
